Sunday, September 13, 2015

The Build Part 2

Setting up the Turnigy 3-In-1 Battery Monitor, Signal Loss and Lost Airplane Alarm

Follow along with this tutorial to set up the CH5 and AUX switches on your Orange T-Six controller.

Now plug the Turnigy 3-In-1 Battery Monitor, Signal Loss and Lost Airplane Alarm into the gear channel on your receiver (the Gear channel lead from the CC3D flight controller will now be unused). Now you should be able to turn the beeper on with the Gear switch on your Orange T-Six (you may need to perform the controller setup again in GCS and save it to your CC3D board). I am only using Functions 1 and 2.




Wiring Diagram

Included Manual

More Building!


strapping the ESC and RX wires down


Video TX mounting

Top plate and battery mount




Video TX frequency table

I set my video TX to 5820 MHz. If you will be flying with other pilots make sure that your video transmitters are broadcasting on a frequency at least 40 MHz away from the next closets transmitter. Otherwise you will interfere with each others video and most likely crash.












1 comment: